Programming your robot.
Here’s a step by step example of the process…
1. Know your task and write it down:
2. Break the task down…
3. Write the pseudocode – writing out the steps – with words and diagrams.
4. Write the code.
Click HERE to see the full code for what I wrote for Hokey-Pokey.
5. Compile the code and download it onto your CBC.
6. Run the program on the robot.
Click HERE to see the Hokey-Pokey program being downloaded and then run on a simple robot.
7. See if your program did what you wanted it to – then make changes if needed or wanted.
Click on the Youtube clip below to see a more dynamic version of an introduction.
**”5 Ways you can learn programming faster” (opens a new tab or window)**
Chuck,
I tried running the ‘download-run’ youtube video off the PYR link with IE v8 and I didn’t see any problem. Could you explain further?
I just tried it again and I see the black box at the bottom of the video. Here is a screen shot – http://screencast.com/t/5eKM7lHV. I have not seen this with any other videos that I have watched.
Chuck
Chuck,
I don’t have an immediate solution. I don’t see this with my IE 8.
Try expanding the display to full screen; then the bottum panel should go away completely after
a few seconds.
Clever & entertaining — well done!